Duplex Pump

AX/VX Gasket Tool

Color LED Camera

Super Grinder [Data Sheet]
Oceaneering’s Super Grinder is designed for the quick and efficient cutting of materials. Its uses have broadened over time, as it can cut through almost anything as long as the thickness is reasonable (up to 1 1⁄2 in). The grinder has a bent axis variable displacement motor.

Flying Lead Orientation Tool

Trash Pump [Data Sheet]
The Trash Pump is used for light dredging tasks to clear pipe line crossing, drill cuttings, and partially buried subsea hardware or equipment. The Trash Pump can clear up to 3 inch solids.

Soft Line Cutter [Data Sheet]
Oceaneering’s Soft Line Cutter is a small hydraulically actuated, manipulator-deployed tool designed to cut up to 1 in diameter fiber rope or hydraulic hose. It consists of a hardened tool steel blade and side plates, a hydraulic cylinder, and a T-handle. The blade is attached to the cylinder ram between the side plates. One side of each of the side plates is open to allow the cutter to be placed on the rope. When the cylinder is extended, the blade acts as a guillotine, severing the rope between the blade and the side plates. The cylinder is then retracted to allow for the next cut.

10K psi Marsten Bentley Pump

ROV Spring Release Shackle [Data Sheet]
The Remotely Operated Vehicle (ROV) Spring Release Shackle is designed to ease the release of a pin from the shackle via spring. This reduces time and potential damage to any equipment.

Alignment Frame [Data Sheet]
The Alignment Frame mounts to the front of an ROV and provides an ROV docking interface. Once docked, the ROV is rigidly attached to the subsea structure. The frame locks onto the tree via two 3 Ton-rated Docking Probes.

The Docking Probes are hydraulically- actuated and are failsafe. In the event of a loss of power on the ROV, the three latch dogs will retract under spring load and the ROV will not remain connected to the tree. The frame is designed to interface with the 3 Ton docking receptacle interface utilizing a customer specified distance between docking receptacles.

Impact Wrench [Data Sheet]
The rugged Oceaneering Impact Wrench is simple to maintain and has many features to give it proven reliability. Torque transmission to the operator is minimal with the swing hammer design.

Class 1-4 Torque Tool

Methanol Injection Skid

Injection Skid

Hard Line Cutter [Data Sheet]
Oceaneering’s Hard Line Cutter is a hydraulically-actuated manipulator-deployed tool designed to cut up to a 1 inch diameter wire rope. It consists of a hardened tool steel blade and side plates, a hydraulic cylinder, and a T-handle. The blade is attached to the cylinder ram between the side plates. One side of each of the side plates is open to allow the cutter to be placed on the rope. When the cylinder is extended, the blade acts as a guillotine, severing the rope between the blade and the side plates. The cylinder is then retracted to allow for the next cut.

Chopsaw